Rain Bird 5000 PLUS Rotor with Seal-A-Matic 4 in. Instruction Manual

Introduction

This manual provides instructions for the installation, operation, and maintenance of your Rain Bird 5000 PLUS Rotor with Seal-A-Matic 4 inch sprinkler. The Rain Bird 5000 PLUS Rotor is designed for efficient and uniform watering of your lawn and garden areas.

Image: Rain Bird 5000 PLUS Rotor with Seal-A-Matic 4 inch sprinkler head, showing its compact design.

Setup and Installation

Proper installation ensures optimal performance and longevity of your Rain Bird 5000 PLUS Rotor. While specific installation steps may vary based on your irrigation system, here are general guidelines:

1. Prepare the Area: Dig a trench for the lateral pipe and a hole for the sprinkler body. Ensure the top of the sprinkler will be flush with the ground level when installed.
2. Connect to Lateral Pipe: Connect the rotor to the lateral pipe using appropriate fittings. The rotor has a 0.75-inch threaded inlet connection.
3. Flush the System: Before installing the rotor, briefly flush the system to remove any debris from the pipes that could clog the sprinkler.
4. Install the Rotor: Thread the rotor onto the fitting. Ensure it is hand-tightened, then use a wrench for an additional quarter to half turn. Avoid overtightening.
5. Backfill: Carefully backfill the soil around the sprinkler, ensuring the top of the rotor is level with the ground.

For visual guidance on adjusting similar Rain Bird rotors, refer to the video below:

Operating and Adjustments

The Rain Bird 5000 PLUS Rotor offers easy adjustments for spray direction and distance to ensure precise watering.

Adjusting Spray Direction (Arc Adjustment):

1. Identify the Left Stop: With the water on, turn the rotor cap to the right until it stops. This is the rotor's left starting position.
2. Set the Left Stop: If the left stop is not in the desired position, turn the entire rotor body to align the left stop with the edge of the area you want to water.
3. Adjust the Right Stop: Use a flat-head screwdriver to turn the arc adjustment screw on the top of the rotor. Turning clockwise increases the arc, and counter-clockwise decreases it. The arc can be adjusted from 40° to 360°.

Adjusting Spray Distance:

• To increase or decrease the spray distance (range from 19 to 32 feet), use a flat-head screwdriver to turn the larger screw located on the top of the rotor. Turning it clockwise will decrease the distance, and counter-clockwise will increase it.

Maintenance

Regular maintenance helps ensure your Rain Bird 5000 PLUS Rotor operates efficiently.

• Self-Cleaning: The rotor features a self-cleaning mechanism that flushes debris during pop-down, helping to prevent clogs.
• Filter Cleaning: Periodically check and clean the filter screen located at the base of the sprinkler body. To access, unscrew the top of the sprinkler and carefully pull out the internal assembly. Remove and rinse the filter screen under running water. Reassemble once clean.
• Nozzle Replacement: If the spray pattern is consistently poor or damaged, the nozzle can be replaced. Unscrew the top of the sprinkler, remove the internal assembly, and carefully replace the nozzle. Ensure the correct nozzle type is used for your application.

Troubleshooting

Here are solutions to common issues you might encounter with your Rain Bird 5000 PLUS Rotor:

• No Water or Low Flow:
  • Check for clogs in the nozzle or filter screen. Clean as described in the Maintenance section.
  • Verify adequate water pressure to the sprinkler.
  • Inspect for kinks or blockages in the supply line.
• Incorrect Spray Pattern:
  • Adjust the spray direction (arc) and distance as described in the Operating section.
  • Ensure the nozzle is correctly installed and not damaged. Replace if necessary.
• Rotor Not Rotating:
  • Check for debris obstructing the rotation mechanism.
  • Ensure sufficient water pressure.
  • The internal gear drive may be worn; consider replacing the rotor assembly.
• Water Leaking from Base:
  • Check for loose connections to the lateral pipe.
  • Inspect the Seal-A-Matic (SAM) check valve for damage or debris.

Specifications

Warranty and Support

For specific warranty information and technical support, please refer to the documentation included with your product or visit the official Rain Bird website. You can also contact Rain Bird customer service for assistance.

Visit the Rain Bird Store for more products and information.