Dritz Stitch Witchery Fusible Bonding Web Instruction Manual

Introduction

The Dritz Stitch Witchery Fusible Bonding Web is a versatile, regular-weight bonding material designed to join fabric pieces without the need for sewing. This product is ideal for creating hems, applying trims, reinforcing belts, and performing various no-sew fabric repairs. It provides a permanent bond that is both washable and dry cleanable, offering a convenient solution for quick fixes and crafting projects.

Image: Dritz Stitch Witchery Fusible Bonding Web, 5/8 Inch x 20 Yards, Regular Weight, White.

Safety Information

• Always use an iron on a heat-resistant surface, such as an ironing board.
• Keep the iron out of reach of children and pets.
• Ensure the iron's temperature setting is appropriate for your fabric to prevent damage.
• Use caution when handling hot iron and fabric to avoid burns.
• Unplug the iron when not in use and allow it to cool completely before storing.

Setup and Preparation

1. Prepare Fabric: Ensure the fabric is clean and dry. For new garments, it is recommended to wash them first to remove any sizing that might interfere with bonding.
2. Preheat Iron: Set your iron to the "Wool" setting. If your iron does not have a "Wool" setting, use a medium-high heat setting suitable for your fabric. Ensure the steam function is turned off unless specifically instructed for a damp press cloth.
3. Prepare Work Surface: Work on a firm, protected surface, such as an ironing board. A cotton cover is recommended for best results.

Operating Instructions

Follow these steps for effective application of Dritz Stitch Witchery:

1. Position Fabric: Turn the garment inside out or flip the fabric over to expose the area where the bond is needed. Fold the hem or seam to the desired position.
2. Place Bonding Web: Cut a piece of Stitch Witchery to the required length. Place the bonding web between the two layers of fabric you wish to bond. Ensure the web is completely covered by fabric.
3. Apply Press Cloth: Lightly dampen a press cloth (a thin cotton cloth) and place it over the area where the bonding web is positioned. This helps to distribute heat and moisture evenly.
4. Iron Application: Press the iron firmly onto the damp press cloth for 10 seconds. Do not slide the iron. Lift the iron and repeat the pressing motion, overlapping slightly, until the entire area is bonded.
5. Cool and Check: Allow the bonded area to cool completely before checking the bond. The bond strengthens as it cools.
6. Re-apply if Necessary: If the bond is not secure, re-dampen the press cloth and repeat the ironing process.

Image: Close-up view of the fusible bonding web, showing its texture.

Maintenance

Once the Dritz Stitch Witchery has been properly applied and secured, the bonded fabric is safe for both washing and drying. The bond is designed to withstand regular laundering without coming undone. Always follow the care instructions for your specific fabric type.

Troubleshooting

• Bond Not Holding: If the fabric layers do not bond securely or if the bond loosens after cooling, ensure that sufficient heat and firm, even pressure were applied during the ironing process. Also, verify that the iron was set to an appropriate temperature for the fabric and that a damp press cloth was used. Re-apply the bonding web following the instructions carefully.
• Web Tangling: The bonding web can sometimes tangle, especially narrower widths. Handle it carefully during placement to prevent twisting.

Specifications

Support

For further assistance or inquiries regarding your Dritz Stitch Witchery Fusible Bonding Web, please visit the official Dritz website or contact their customer support. Product documentation, including a user guide in PDF format, may also be available on the product's Amazon page under the 'Documents' section.