Document

User Manual

Arlo Pro 2 Image

Wire-Free HD Security Camera

Arlo Pro 2 Wire-Free HD Security Camera

 

What’s Included

Thank you For choosing Ario Pro 2. Getting started is easy.

FIG 1 What's Included

 

Use Your Camera Wire-Free

Before using your camera wire-free, you must insert the battery.

Note: You do not need to insert the battery if you are connecting your Ario camera to an AC power outlet.

FIG 2 Use Your Camera Wire-Free

To insert the battery

  1. Unlock the battery compartment by pressing and holding the latch.
  2. Gently pull the battery door back to open the compartment.
  3. Align the battery contacts.
  4. Insert the battery.
  5. Close the battery door.

 

Sync Your Camera With the Base Station

  • Bring the camera within 1 to 3 feet (30 to 100 centimeters) of the base station.
    Note: Cameras must be synced one at a time.

FIG 3 Sync Your Camera With the Base Station

  • Press the Sync button on the top of the base station for about two seconds.
  • Release the button.
  • Wait for the Sync Status LED to blink green.

FIG 5 Sync Your Camera With the Base Station

  • Press the Sync button on top of the camera  for about two seconds.
  • Release the button.
    The LED lights as follows:
    -A blue LED on the camera blinks slowly when the sync process starts.
    -The blue LED blinks rapidly to confirm sync.
    -The LED blinks amber if the sync is not successful

If the LED blinks amber, you must repeat the sync process.

Note: Ario’s range varies depending on environmental factors, including physical obstructions. construction materials. and wireless interference.

 

Charge Your Arla Battery

The Arla battery is fully charged when it leaves the factory.

To recharge the battery:

  1. Place the camera indoors.
    If you are using the camera outside, bring it inside while charging the battery.
  2. Connect the power adapter cable to the camera power adapter.
    Note: You must use an Arla Pro 2 power adapter and cable to charge the battery.
  3. Connect the other end of the adapter cable to the camera.
  4. Plug the power adapter into an electrical outlet.

FIG 6 Plug the power adapter into an electrical outlet.

The camera LED lights solid blue when the camera battery is fully charged.

 

Use Your Camera Plugged In

You can use your camera wire-Free, powered by the battery, or while plugged into an AC power outlet.

To use your camera plugged in:

  1. Place the camera indoors or use the optional outdoor power adapter, sold separately, when placing outdoors.
  2. Connect the power adapter to an AC electrical outlet.

 

You’re Done!

Congratulations! Your Arla camera is set up and ready to go.

To view useful tutorial videos, find troubleshooting tips, or get support, visit
http://support.arlo.com.

 

Camera LED Guide

FIG 7 Camera LED Guide

FIG 8 Camera LED Guide

Notes

 

 

FIG 9 Compliance

 

 

Read More About This Manual & Download PDF:

Arlo Pro 2 Wire-Free HD Security Camera User Manual – Optimized PDF
Arlo Pro 2 Wire-Free HD Security Camera User Manual – Original PDF

Questions about your Manual? Post in the comments!

Leave a comment

Your email address will not be published.