Apple LOGO

Apple A2187 Airtag Safety

Apple A2187 Airtag Safety

Regulatory Compliance Information

FCC Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • If the equipment is connected to an outlet, connect it to an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

the electromagnetic compatibility (EMC) and wireless compliance and negate your authority to operate the product.
This product has demonstrated EMC compliance under conditions that included the use of compliant peripheral devices and/or shielded cables between system components. It is important that you use compliant peripheral devices and/or shielded cables between system components to reduce the possibility of causing interference to radios, televisions, and other electronic devices. This product was tested for EMC compliance under conditions that included the use of Apple peripheral devices.

  • Responsible party (contact for FCC matters only):
  • Apple Inc.
  • One Apple Park Way, MS 911-AHW
  • Cupertino, CA 95014 USA
  • apple.com/contact

ISED Canada Compliance
This device complies with ISED Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device

Frequency Maximum Power

  • 2.4GHz (Bluetooth®) < 100mW
  • 6.0 – 8.5 GHz (Ultra Wideband) < 0dBm/50MHz

Battery Disposal Information
California: The coin cell battery in your device contains perchlorates. Special handling and disposal may apply. Refer to dtsc.ca.gov/hazardouswaste/perchlorate.

Apple and the Environment
At Apple, we recognize our responsibility to minimize the environmental impacts of our operations and products. For more information, go to
apple.com/environment.

Disposal and Recycling Information

The symbol above indicates that this product and/or battery should not be disposed of with household waste. When you decide to dispose of this productand/or its battery, do so in accordance with local environmental laws and guidelines. For information about Apple’s recycling program, recycling collection points, restricted substances, and other environmental initiatives, visit apple.com/environment.

Documents / Resources

Apple A2187 Airtag Safety [pdf] Instructions
A2187, BCGA2187, AirTag

References

Leave a comment

Your email address will not be published.