Document

anko-KC43151325 -Rechargeable-Automatic-Soap -Dispenser-logo

anko KC43151325 Rechargeable Automatic Soap Dispenser

anko-KC43151325 -Rechargeable-Automatic-Soap -Dispenser-product

Safety Instructions

To ensure proper operation of this appliance, please read this instruction manual carefully before you use the appliance and save it for further reference.

Battery and Appliance Disposal

Eco-Friendly Tips

Please do not dispose of the appliance containing the lithium batteries with the normal household waste. Batteries contain substances harmful to our environment, please do not dispose the appliance with the normal household waste, instead, hand it over to an official recycling point.

Trouble Shooting

anko-KC43151325 -Rechargeable-Automatic-Soap -Dispenser-fig-1

CAUTION

This appliance has a lithium battery. Do not place or store the appliance for long periods of time in a hot or humid environment. If you do not intend to use the appliance for a long time, store the appliance after is fully charged.

What should you do if the soap dispenser doesn’t spray gel?
  • Step 1: Confirm the soap dispenser is fully charged before using.
  • Step 2: If the issue is not resolved, please use the flexible pipe to inject warm water to flush the internal pipe as shown above. Repeat 2-3 times until the blockage is cleared and water flows freely out of the spot
  • Remarks: Step 2 may be followed as part of the ongoing maintenance of the product.anko-KC43151325 -Rechargeable-Automatic-Soap -Dispenser-fig-2

Componentsanko-KC43151325 -Rechargeable-Automatic-Soap -Dispenser-fig-3

  1. Power Button
  2. Spout
  3. Infrared Sensor
  4. Main Body
  5. 300ml soap tank
  6. USB charging intertace
  7. Indicator light
  8. Worldwide USB Type C cable Rating: 1.5W, Voltage: 5v)

Usage

  1. Open the soap tank by rotating it gently in a clockwise direction.
  2. Open the interface protection cover, and connect USB cable to a suitable adapter for charging normal charge time is about 3-5 hours
  3. Most hand sanitizers can be used in dispensers but not foaming soaps. (not suitable for foaming liquids)
  4. Power on: Press and hold the Power Button for 1-2 seconds to switch it o (White indicator light flashes once)
    1. Power off: Press and hold the Power Button for 1-2 seconds to switch it off (Red indicator light flashes)
  5. To use, place your hand approximately 5cm under the sensor and wait for the liquid to be dispensed.
  6. There are 2 adjustable levels
    1. Press and hold the power button to power on (White indicator light flashes once):
    2. At this time, the machine is at first level mode and the gel output is 1.3ml
    3. Press the power button once again (White Indicator light flashes twice):
    4. At this time, the machine is at high-level mode and the gel output is 3ml

Charginganko-KC43151325 -Rechargeable-Automatic-Soap -Dispenser-fig-4

  1. Normal charging time is about 3-5 hours and can be used for about 2-3 months. We suggest charge it up to 6-8 hours for first time.
  2. The white indicator light is on while charging, and the white indicator light will flash when it is full charged.
  3. Red indicator light will flash if there is not enough power and charging is required.
  4. Ensure the charging adapter used is compatible with a 5V/1A rating.

Attentions

  1. Please place the unit on a dry level surface. without water covering.
  2. Please use the liquid soap/hand sanitizer which contains low concentration.
  3. Please turn the unit off before it is moved.
  4. DO NOT expose the unit under to direct the sun or strong light, which may interfere IR sensor system.
  5. When not used for an extended time, drain and clean with a soft towel. Store in a dry place.
  6. Store the manual in a safe place for future reference.

Product Specification

  • Model: PS-204
  • Built-in battery: 1800mA Lithium battery
  • Input Voltage: 5V
  • Power: Max. 1.5W
  • Volume: 300ml
  • charge time: 3-5 hours
  • use time: about 2-3 months

Storage Instructions

  1. Press and hold the switch to turn off the machine.
  2. Turn gently to open the soap tank, pour out the remaining liquid in the soap tank.
  3. Rinse the soap tank with clean water, and gently rotate it in a clockwise direction to clean it.
  4. Press and hold the power button for 1-2 seconds to turn on the machine, put your hand under the sensor, and let clean water go through the pipe of the machine until water comes out from the spout.
  5. Rotate and remove the soap tank and rinse it with clean water. Wipe the soap tank and body with a dry cloth.
  6. Then press and hold the switch to turn off the machine again.
  7. The soap dispenser should be stored in a place that is safe, dry and clean.

Cleaning & Maintenance

1. Do not immerse the appliance in water. Clean the appliance surface with a dry cloth or with cloth moistened with water.
2. Do not use any lubricant, detergent, polishing agents, alcohol, steel wool, abrasive cleansers, chemicals or corrosive liquids on this appliance.

Documents / Resources

anko KC43151325 Rechargeable Automatic Soap Dispenser [pdf] User Manual
KC43151325 Rechargeable Automatic Soap Dispenser, KC43151325, Rechargeable Automatic Soap Dispenser

Leave a comment

Your email address will not be published.