50MM Faux Wood Venetian Blind
210x297mm
Description
50MM FAUX WOOD Venetian Blind
Installation Instructions
Quantity /item
Valance Clip
90X150CM
2
120X150CM
3
150X150CM
3
180X150CM
4
Brackets
2 2 2 2
Hold Down Bracket
2 2 2 2
Centre Support Bracket
Short Screws (To install the
hold down bracket)
1
4
2
4
2
4
3
4
Long Screws
12 16 16 20
Cleat
1 1 1 1
Recess Mount: Inside Frame
1
Decide whether your blind will be mounted outside or inside the window frame.
A: Inside frame
B: Outside frame
Outside Mount: Outside Frame
2
Hold the blind against the window and where the brackets meet the wall, mark the screw
holes by pencil.
50MM FAUX WOOD Venetian Blind
Installation Instructions
3
Depending on your bracket mount preference, drill holes and screw in
bracket.
4
Insert the headrail into the brackets. Ensure the blind cords and wand are
facing toward you.
A: Inside frame
C: Ceiling mounting
B: Outside frame
To stop the blind from shaking, screw the
5
hold down bracket clips onto the bottom of the window frame. Then clip the bottom
rail of the blind into the hold down bracket.
6
Attach the valance clips to the valance, and fix it to the top front of the blind.
7
The cleat provided should be fixes to a timber frame, masonry or stud behind plaster wall ensuring that the cord is taut at all times. The cleat must be installed a minimum of 1600mm above floor level.
C: Ceiling mounting If mounting to the ceiling, ensure a secure anchor point is found such as masonry or ceiling truss.
FRONT
50MM FAUX WOOD Venetian Blind
Installation Instructions
WARNING: Important Safety Instructions:
Cleat
50MM FAUX WOOD Venetian Blind
Installation Instructions
HOW TO OPERATE
1
To lower blind, pull cords down and away slightly to release lock.
2
To raise blind, pull cords down until you reach your desired height then hold down cords
horizontal to lock.
Cord cleat must be 1600mm above floor level
1600mm
Floor Level
3
The blinds are tilted or angled by rotatig the wand.
CARE INSTRUCTIONS: OPEN BLIND COMPLETELY. USE A VENETIAN BLIND DUSTER OR A CLEAN DAMP CLOTH TO WIPE BOTH SIDES OF EACH SLAT.
WARNING: To avoid creating a possible strangulation hazard for children, the corded internal window covering must be installed in such a way that a loose cord cannot form a loop 220mm or longer, at a height of less than 1600mm above floor level; SUGGESTIONS FOR INSTALLING CORDED INTERNAL WINDOW COVERINGS: i) A cord guide may be installed lower than 1600mm above floor level if the *cord is sufficiently secured or tensioned to prevent a loop 220mm or longer from being formed; and ii) If a cord guide is installed lower than 1600mm above floor level it must be designed to prevent a child from being able to remove the cord; and ii) lf a *cleat is used to secure the cord it must be at least 1600mm above floor level because a child is capable of unwinding a cord from a cleat.
*cord: rope, strap, string, chain, line or wire used to manipulate a corded internal window covering. *cleat: a device having a bar with arms around which a cord can be wound and that can be attached to a wall or other structure.
! WARNING
WARNING: CURTAIN AND BLIND CORDS HAVE CAUSED THE DEATH OF YOUNG CHILDREN AND MUST BE INSTALLED SO THAT THEY ARE NOT A STRANGULATION HAZARD. FOLLOW THE INSTALLATION INSTRUCTIONS.
BACK
Documents / Resources
 |
anko 50MM Faux Wood Venetian Blind [pdf] Instruction Manual 50MM Faux Wood Venetian Blind, Wood Venetian Blind, Venetian Blind, 50MM Faux, Blind |
