anko logoCat Tower XL

anko 43072910 Cat Tower XL

Contents

anko 43072910 Cat Tower XL- Contentsanko 43072910 Cat Tower XL- Contents 2

Instructions

Step 1.
Screw the bottom board (No.1 x1) to the cat house (No.2 x1) using the hex key and screw (B x 1). Screw the two poles (No.9 x 1 & No.10 x 1) into the bottom board using the hex key and screws (A x 2). Insert the screws (C x 2) into the top of the poles (No.9 x 1 & No.10 x 1).anko 43072910 Cat Tower XL- Step 1Step 2.
Screw poles (No.12 x 2) into the cat house (No.2 x 1) using the hex key and screws (A x 2). Insert the screws (C x 2) into poles (No.12 x 2).

anko 43072910 Cat Tower XL- Step 2Step 3.
Place the middle board (No.3 x 1) on. Screw the four poles (No.9 x 1 & No.10 x 1 & No.11 x 1 & No.12 x 1) on screw C, then insert the screws (C x 3) into poles (No.9 x 1 & No.10 x 1& No.12 x 1). Refer to the image below.anko 43072910 Cat Tower XL- Step 3

Step 4.
Screw round board (No.4 x 1) on screw C. Put the middle pet bed (No.8 x 1) on pole (No.12 x 1), screw pole (No.12 x 1) on screw C, insert the screw (C x 1) into pole (No.12 x 1) .anko 43072910 Cat Tower XL- Step 4

Step 5.
Put the top board (No.6 x 1) on. Screw three poles (No.11 x 1 & No.13 x 1 & No.14 x 1) on screw C as shown below.anko 43072910 Cat Tower XL- Step 4

Step 6.
Put the top board (No.6 x 1) on. Screw top square pet bed (No.7 x 2) on poles (No.13 x 1 & No.14 x 1), screw round board (No.4 x 1) on pole (No.11 x 1). Using the Hex key and screw (B x 1) to screw-top board (No.6 x 1) together with the round cat house (No.5 x 1).

anko 43072910 Cat Tower XL- Step 6

WARNING: Pet toy – Not intended for children.
It is the responsibility of the pet owner if this toy is suitable for their pet’s style of play.
No pet toy is indestructible and can be damaged during play.
For your pet’s safety, inspect regularly and remove if damaged.
Always supervise your pet during play.

Documents / Resources

anko 43072910 Cat Tower XL [pdf] Instructions
43072910, Cat Tower XL

Leave a comment

Your email address will not be published.