Amazon Basics CY83RR-7 Portable Digital Radiator Heater
IMPORTANT INSTRUCTIONS
Read these instructions carefully and retain them for future use. If this product is passed to a third party, then these instructions must be included.
When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or injury to persons including the following:
WARNING
Risk of electric shock! To reduce the risk of fire or electric shock do not use with an extension cord.
- Read all instructions before using this heater.
- This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this heater. Keep combustible materials such as furniture, pillows, bedding, papers, clothes, curtains at least 3 feet (0.9 m) from the front of the heater and keep away from the sides and rear.
- Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.
- Do not operate any heater with a damaged cord or plug after the heater malfunctions, has been dropped or damaged by any manner. Discard heater or return to authorized service facility for examination and/or repair.
- Do not use outdoors.
- This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heater where it may fall into a bathtub or other water container.
- Do not run cord under carpeting. Do not cover cord with throw rugs, runners or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
- To disconnect heater, turn controls to off, then remove plug from outlet.
- Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater. Oil in the heater is permanently sealed and does not require refilling.
- This heater is filled with a precise quantity of special oil. Repairs requiring opening of the oil container are only to be made by a professional repair center that should be contacted if there is an oil leak.
- When scrapping the heater, follow the regulations concerning the disposal of oil.
- A heater has hot and arcing or sparking parts inside. Do not use it In areas where gasoline, paint or flammable liquids are used or stored.
- Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or relocatable power tap (outlet/power strip).
- To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked.
- This product draws up to 1500 W of power. To prevent overloading of the electrical circuit, do not plug the product into a circuit with other appliances already connected.
- The plug in the socket outlet must always be easily accessible so that it can be disconnected in an emergency.
Polarized Plug
This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug will fit the outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not modify the plug in any way.
SAVE THESE INSTRUCTIONS
Intended Use
- This product is intended for temporarily heating residential rooms with an effective area coverage of 120-160 ft2 (11-15 m2).
- This product is intended for household use only. It is not intended for commercial use.
- This product is intended to be used in dry indoor areas only.
- No liability will be accepted for damages resulting from improper use or non-compliance with these instructions.
Product Description
- Power on/off button
- Decrease temperature button
- Increase temperature button 0 Timer button
- ECO mode button
- Display
- Radiator fins
- Handle
- Air vents
- Rear caster wheels
- 0 Power cord with plug
- Front caster wheels
- Cord hooks
- Remote control
Before First Use
- Check the product for transport damages.
- Remove all the packing materials.
- Remove the protective strip from the remote control’s battery compartment.
- Before connecting the product to the power supply, check that the power supply voltage and current rating corresponds with the power supply details shown on the product rating label.
Risk of suffocation! Keep any packaging materials away from children – these materials are a potential source of danger, e.g. suffocation.
Installing Caster Wheels
- Turn over the product and screw the front caster wheels (L) onto the threads using the provided wing nuts.
- Attach the rear caster wheels (J) by using the U-shaped bolt and locking it in between the last two radiator fins.
- Turn the product back over once the caster wheels (L) has been installed and before switching on the product.
Installing Cord Hook
- Insert the cord hook (M) into the air vents (I) matching up with the holes for the screws.
- Tighten the screws until both cord hooks (M) are secure.
NOTICE
Cord hooks (M) can be installed on either side of the product air vents (I).
Operation
Positioning the product
Place the product on a flat and stable surface to avoid risk of tipping it over.
Connecting
- Fully unwind the power cord (K) and connect the plug to a suitable socket outlet.
- Once connected to the socket outlet, the display (F) shows OF. The product is now on standby mode.
Switching on/off
- To switch on the product, press the power button @ (A) on the control panel or remote control.
- The display (F) blinks LO for 3 seconds, then shows the current room temperature. The product is operating on its lowest power setting.
- Press the power button @ (A) again to set the high power mode. The display (F) shows HI and the product is operating on its highest power setting.
- To switch off the product, press the power button@ (A) on the control panel or remote control twice until the display (F) shows OF
Temperature setting
- To adjust the temperature manually, press the increase temperature @ (C) button or decrease temperature (9 (B) button on the control panel or remote until the desired temperature has been reached.
- The maximum temperature setting is 80 °F (26.6 °C)
- The minimum temperature setting is 40 °F (4.4 °C)
NOTICE
The product gradually heats up once the desired power temperature has been selected.
NOTICE
When the room temperature meets the setting temperature, the product may continue to work for a while so that the room can maintain its temperature.
Timer setting
- To set the timer, press the timer® (D) button. The display (F) flashes [J[J and C:) icon is shown on display (F).
- Immediately press or hold the timer® (D) button again until the desired length of time has been reached.
- The display (F) flashes for 3 seconds and then starts to count down.
- The product automatically switches off once the timer countdown has finished counting down. The C:) icon goes off.
- To switch off the timer, press the timer® (D) button until the display (F) flashes QQ. The C:) icon goes off.
NOTICE
The timer jumps one hour for each press of the button from a minimum of 1 to a maximum of 24 hours.
Eco mode
- The power setting cannot be adjusted whilst in ECO mode. If the room temperature reaches 104 °F (40 °C), the product will switch off automatically to reduce power consumption. Should the room drop below 104 °F (40 °C), the product will switch on automatically.
- During ECO mode, the products display (F) show the current room temperature.
- Press the ECO mode button (§ (E) to activate ECO mode.
- Press the any other button to deactivate ECO mode.
Cleaning and Maintenance
WARNING
Risk of electric shock! To prevent electric shock, unplug the product before cleaning.
WARNING
Risk of electric shock! During cleaning do not immerse the product in water or other liquids. Never hold the product under running water.
Cleaning
- To clean the product, wipe with a soft, slightly moist cloth.
- Never use corrosive detergents, wire brushes, abrasive scourers, metal or sharp utensils to clean the product.
Replacing remote control battery
- Remove the battery holder from the remote control (N).
- Replace the used battery with a new CR2025 3 V battery. The positive pole(+) must be facing upwards.
- Slide the battery holder back in place.
NOTICE
Replace the battery if the range of the remote control decreases noticeably or if the heater cannot be controlled via remote control.
Storage
- Wrap the power cord (K) around the cord hooks (M).
- Store the product in its original packaging in a dry area. Keep away from children and pets.
Maintenance
Any other servicing than mentioned in this manual should be performed by a professional repair center.
Troubleshooting
Unexpected smell
This is the result of dust or other debris accumulating on the heating element. This is normal during first use and after prolonged storage. Make sure the product is placed in a well ventilated area. Keep the product switched on, until the smell disappears.
Safety Functions
Tip-over switch
- The product automatically stops heating when it tips forward or backward. The heating element and indicator light switches off.
- After placing the product into normal position, restart the product.
Battery Disposal
Do not dispose of used batteries with your household waste. Take A them to an appropriate disposal/collection site
Specifications
- Model:B0828YJ33N
- Voltage/frequency:120V AC 60 Hz
- Power consumption: max. 1500 W
- Remote control battery: CR2025, 3 V
- Dimensions 0N x H x D): approx. 13.1 x 9.8 x 26.3″ (33.5 x 25 x 67 cm)
- Net weight:approx. 16.9 lbs (7. 7 kg)
Feedback and Help
Love it? Hate it? Let us know with a customer review.
AmazonBasics is committed to delivering customer-driven products that live up to your high standards. We encourage you to write a review sharing your experiences with the product.
amazon.com/review/review-your-purchases#
amazon.com/gp/help/customer/contact-us
FAQS
I see a button with a clock icon placed next to the eco mode button…is this a timer? If not, what does it do?
Yes, it’s a timer
what is the temperature setting range?
You can set it up to 80 degrees.
What is the warranty?
1 year
What is the eco setting? When I use it, the temperature shoots up higher than what I have set.
The basic model does not have an eco setting cannot imagine what that would do
Does the manual control version have overheat protection?
yes, it has overheat protection.
Does heater need to be plug into outlet?
Yes, it is an electric heater.
how many square feet is this recommended for?
10KSFNah, try 1,000 SF room
How long can you leave it unattended?
Technically, all instructions for any heater will instruct you to not leave unattended. He doesn’t get extremely hot to the touch.
Can you buy a replacement control?
Yes you can get a replacement, just got to the heater and in the bottom they show you item can be replace
How long is the power cord?
about 72inch
the heat it gives at 80 deg is not sufficient enough! what should i need to do? window’s closed. no sweat. suggest better brand plz
radiators are radiators … no brand acts differently …
does it have a timer? like set to run for a few hours then auto shut?
No. It does not have a timer, but it does have a thermostat, so it will shut the heat off once it gets to a certain level. I have found the unit to be totally silent, unobtrusive, cool enough to touch, safe, and more than enough to keep a 15 x 15 foot room at the perfect temperature.
VIDEO