ADB30WT Self-Powered Wireless Doorbell
ADB30WT
ADB30ZT
User Manual
Disconnect indoor bell
- Unplug the inner bell.
- Press and hold button
while putting the inner door bell back into the socket. - Wait until the blue light goes out.
- The inner doorbell is now disconnected.
Specifications
| Indoor bell power supply: | 220-240V AC, 50Hz |
| Outdoor bell power supply: | Battery-free |
| Transmission range: | Up to 200 meter (depending on the environment) |
| RF information: | Type AM |
| Transmission frequency: | 433.92 MHz |
| Transmission power: | <0 dBm |
| Number of ringtones: | 36 |
| Volume levels: | 4 |
| Water resistant: | IP44 |
DECLARATION OF CONFORMITY
Hereby, Commaxx declares that the radio equipment type Alecto ADB30 is in compliance with directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address:
https://commaxx-certificates.com/doc/adb30_doc.pdf
- Indoor bell LED
- Speaker
- Pairing and volume setting button
- Ringtone change button
- Doorbell LED
- Doorbell button
Do not place the doorbell directly on a metal surface or on a surface containing metal.
This will have a negative effect on the doorbells operation.
Extra
Multiple indoor bells
Commaxx B.V.
Wiebachstraat 37
6466 NG Kerkrade
The Netherlands
www.alecto.nl
Documents / Resources
 | Alecto ADB30WT Self-Powered Wireless Doorbell [pdf] User Manual ADB30WT, ADB30ZT, ADB30WT Self-Powered Wireless Doorbell, Self-Powered Wireless Doorbell, Wireless Doorbell, Doorbell |