Powrlink Light Safety Instructions – Please Read!
OCS60 Portable Scale
To avoid injuries or accidents, please pay special attention to our safety instructions on device use and correct use. This device should only be used for fitness strength testing. It should only be used by individuals aged 21 years and older and not be used for any other purposes. Please note that using the device for other purposes or above its rated capacity can lead to injury and/or health problems. This device is intended for use by adults aged 21 and older only. Individuals under 21 years must not use or access the Powrlink Light or its connected devices under any circumstances.
Before Using the Powrlink Light
Before using the device for the first time, consult your doctor, therapist, or trainer to ensure the device is safe and appropriate for your abilities and readiness for exercise and can correctly assess your abilities and readiness for exercise that fits your individual needs. Start slowly when first using the device and don’t overburden yourself. When starting out, we recommend exercises that have low resistance. In addition, we recommend the presence of a partner who can support you and is also 21 years or older. Powrlink Training is based on the concept of connecting Powrlink Light to fitness devices that generate resistance that can be measured using a scale. Only use with aeroSling Slingtrainers, revvll Ropetrainers, Powerbands and Pain Train sleds.
Before Each Training Session
Check for correct assembly. Are all components of the Powrlink Light and it’s connected fitness devices properly assembled and securely connected?
Device Setup
Only use the device on stable and sturdy structures that can take a tensile load of a minimum of 500 kg (1100 lbs) at the connection point to the fitness device and its holding structure. Please note that the structure does not only have to support you but depending on the exercise more than your own bodyweight. Ensure that you always have enough room (3 m/120 in in every direction) and a secure surface for your workout
Product Specifications
- BLE Name: POWRLINK
- BLE Data Transmission: Real-time dynamic weight data (250ms interval)
- Max Load Capacity: 300 kg
- Precision: 100 g
- Minimum Weight Value: 100 g
- Overload Limit: 305 kg (displays “O-Ld”)
- Units: kg, lb, N
- Buttons: ON/OFF, UNIT, TARE
- Power Supply:
o Built-in 3.7V rechargeable lithium battery
o 3x 1.SV AAA batteries (4.5 total input)
o Low Voltage Detection:
o At3V, the battery icon Nashes for IU seconds (middle bar disappears), then displays “Lo” and shuts off
o Battery Level Display:
o 3 hars: 4.2V-3.9V
o 2hars: 28V-3.5V
o Lbar: 3.4V-3.1V
o Flashing icon: 3V - Backlight: LED blue light
- Buzzer: 2KHz {sounds only on powereofT)
- Store in a cool, dry place to prevent malfunctions,
- Only use a compatible charger with max 3.7V to avoid battery damage
Functional Instructions
- Power On and Unit Scicction
The scale powers on in kg by default.
Selected units are saved even afler powering off (unless power is lost for an extended period). - Power
On: Press the ON/OFF button briefly.
Off: Press and hold the ON/OFF button for 2 seconds. - Unit Conversion
Press the UNIT button to cycle through: kg — Ib —+ N — kg. - TARE Function
Press the TARE button to reset the scale to zero or remove the tare weight. - Weighing and Peak Modes
Default: Weighing Moue (realetime weight display).
Toggle: Press and hold TARE for 3 seconds to switch to Peak Made (shows maximum weight only, no negative values),
Return: Press and hold TARE for 3 seconds to switch back to Weighing Mode. - BLE Connectivity to the App
Pairing: Backlight blinks until connected, then stays steady.
Power-Off Signal: The scale notifies the app when shutting down.
App Features: Use the app to change units or power off the scale remotely. - Resetting BLE.
If BLE freezes, press and hold ON/OFF for 6 seconds to reset and restart. - Auto Power Off
The scale turns off after 5 minutes of inactivity.
Last Weight: On restart (without power loss), it briefly shows the last weight before resetting to zero.
Battery Update: Updates every 30 seconds while charging and on each power-on. - Buzzer
Sounds only when powering off (not for other operations).
Calibration Instructions
From power-off state, press and hold UNIT + ON/OFF together to enter calibration mode.
Follow the same steps:
- Calibrate with a 100 kg weight.
- Calibrate with a 300 kg weight.
- Calibration completes, and the scale returns to Weighing Mode.
Note: If no action is taken for 5 minutes during calibration, the scale powers off. Alternatively, press and hold ON/OFF for 2 seconds to exit manually,
Certifications & Registrations
CE and RoHS
EN 300 328
FCC Part 15.247
WEEE ElektroG DE25537141
Manufactured for
aerobis fitness GmbH, Dieselstr. 6, 50859 Cologne, Germany // office@acrobis.com
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
–Consult the dealer or an experienced radio/TV technician for help.
FCC RF Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Documents / Resources
 | aerobis OCS60 Portable Scale [pdf] Instructions OCS60, OCS60 Portable Scale, Portable Scale, Scale |