TODIMART T3 Electric Scooter User Manual

1. Introduction

Welcome to the TODIMART T3 Electric Scooter user manual. This guide provides essential information for the safe assembly, operation, maintenance, and troubleshooting of your new electric scooter. Please read this manual thoroughly before your first ride to ensure optimal performance and safety.

2. Important Safety Warnings

⚠️ Please mind potential fire risk and strictly follow the instruction manual for charging and storage. While using the product, please wear protective equipment and fully comply with the applicable law and regulations.

• Always wear a helmet and other protective gear (knee pads, elbow pads) when riding.
• Ensure all screws and quick releases are securely fastened before each ride.
• Do not ride in heavy rain, on slippery surfaces, or through puddles deeper than 2 cm.
• Avoid riding on steep slopes exceeding the scooter's climbing capacity.
• Do not allow children under 12 years old to operate the scooter without adult supervision.
• Adhere to local traffic laws and regulations for electric scooters.
• Do not perform stunts or sudden maneuvers.
• Keep fingers and hair away from moving parts.

3. Technical Specifications

4. Assembly and Unfolding

The TODIMART T3 electric scooter comes largely pre-assembled. Initial setup primarily involves unfolding the scooter and securing the handlebar stem.

4.1 Unfolding the Scooter

1. Place the scooter on a flat surface.
2. Locate the folding mechanism at the base of the handlebar stem.
3. Release the locking lever/clasp.
4. Carefully lift the handlebar stem until it clicks into an upright, locked position.
5. Ensure the folding mechanism is securely engaged and the stem is stable.
6. Attach the handlebars if they are separate, ensuring they are tightened firmly.

4.2 Initial Check

Before your first ride, perform the following checks:

• Verify that the tires are in good condition and free from damage.
• Test both the electronic and disc brakes to ensure they are functioning correctly.
• Confirm that the headlight and taillight are operational.
• Check that the handlebar is firmly attached and does not wobble.

5. Charging the Battery

To ensure the longevity of your scooter's battery, follow these charging guidelines:

1. Ensure the scooter is turned off before charging.
2. Locate the charging port, usually on the side of the deck.
3. Connect the charger to the charging port, then plug the charger into a power outlet.
4. The charger indicator light will typically show red during charging and turn green when fully charged.
5. Charging time is approximately 4-6 hours for a full charge.
6. Do not overcharge the battery. Disconnect the charger once the battery is full.
7. Only use the original charger provided with your scooter.

6. Operating the Scooter

6.1 Power On/Off

Press and hold the power button on the display to turn the scooter on or off.

6.2 Display and Controls

The handlebar features an LCD display that shows:

• Speed Display: Current riding speed.
• Mode Screen: Indicates the current speed mode (ECO, D, S).
• Bluetooth Indicator: Shows connectivity status with the mobile application.
• Battery Indicator: Displays the remaining battery level.
• Power Switch: Used to turn the scooter on/off and cycle through modes.

6.3 Speed Modes

The scooter offers three speed modes:

• ECO Mode: Energy-saving mode for longer range and lower speed.
• D Mode (Drive): Standard mode for balanced speed and range.
• S Mode (Sport): High-performance mode for maximum speed.

Press the power button briefly to switch between modes while the scooter is on.

6.4 Mobile Application Control

The TODIMART T3 can be controlled via a dedicated mobile application (available for download on your smartphone's app store). Connect your scooter via Bluetooth to access features such as:

• Lock/Unlock the scooter.
• Customize maximum speed settings.
• Activate/deactivate cruise control.
• View detailed ride statistics.

6.5 Riding Instructions

1. Place one foot on the deck and push off with the other foot to gain initial momentum.
2. Once moving, gently press the accelerator lever to engage the motor.
3. Place both feet on the deck.
4. To slow down, release the accelerator and gently apply the brake levers.
5. Use the headlight for night riding and ensure the taillight is visible.

7. Folding and Storage

The TODIMART T3 electric scooter features a convenient one-step folding mechanism for easy portability and storage.

7.1 Folding Steps

1. Ensure the scooter is powered off.
2. Locate the folding lever/clasp at the base of the handlebar stem.
3. Release the locking mechanism.
4. Gently push the handlebar stem downwards until it folds and locks into place with the rear fender.
5. The folded dimensions are approximately 108 x 43 x 49 cm, and the net weight is less than 12 kg, making it easy to carry.

7.2 Storage

Store the scooter in a cool, dry place away from direct sunlight and extreme temperatures. Avoid storing it in areas with high humidity or corrosive substances. For long-term storage, ensure the battery is charged to about 50-70% and recharge it every 1-2 months to prevent deep discharge.

8. Maintenance

Regular maintenance will extend the life of your TODIMART T3 electric scooter.

• Cleaning: Wipe the scooter with a damp cloth. Do not use high-pressure water jets or immerse the scooter in water.
• Tires: Regularly inspect the 8.5-inch honeycomb solid tires for wear and tear. While solid tires reduce puncture risk, they can still degrade over time.
• Brakes: Check the functionality of both the electronic and disc brakes before each ride. Adjust or replace brake pads as necessary.
• Battery Care: Avoid fully draining the battery. Charge it regularly, even if not in use, to maintain battery health.
• Fasteners: Periodically check all screws and bolts to ensure they are tight.

9. Troubleshooting

Here are some common issues and their potential solutions:

• Scooter does not turn on: Check if the battery is charged. Ensure the power button is pressed and held correctly.
• Motor not engaging: Ensure the scooter has initial momentum before pressing the accelerator. Check battery level.
• Reduced range/speed: Battery may not be fully charged, or it could be affected by cold weather, uphill riding, or heavy load.
• Brakes not effective: Inspect brake pads for wear. Ensure brake cables (for disc brake) are properly tensioned.
• App connectivity issues: Ensure Bluetooth is enabled on your smartphone and the scooter. Try restarting both devices.

If you encounter persistent issues not covered here, please contact customer support.

10. User Tips

• Always perform a quick safety check before each ride, including brakes, tires, and battery level.
• Familiarize yourself with local regulations regarding electric scooter usage, including speed limits and where you can ride.
• For optimal battery life, try to keep the battery charge between 20% and 80% during regular use.
• When riding at night, ensure your lights are on and consider wearing reflective clothing for increased visibility.
• Utilize the mobile application to customize settings and monitor your scooter's performance.

11. Warranty and Support

The TODIMART T3 Electric Scooter comes with a one-year warranty from the date of purchase, covering manufacturing defects. This warranty does not cover damage caused by misuse, accidents, unauthorized modifications, or normal wear and tear.

For warranty claims, technical support, or any questions regarding your scooter, please contact TODIMART customer service. Please have your purchase receipt and scooter model information ready when contacting support.