Roof Curb Flashing Detail
Roof Curb Installation Instructions
- Cut a square or round hole 5″ in diameter.
- Total number of screws or nails needed for flange = 8
- Recommended installation screw: #10 x 1 1/2″ Sheet Metal Screw
- Flash roof curb onto roof according to specifications of the roof manufacturer.
- Screws are not included.
Documents / Resources
|Active Ventilation RC-3-H6 Tall Aluminum Roof Curb [pdf] Instruction Manual|
RC-3-H6, Tall Aluminum Roof Curb, Aluminum Roof Curb, RC-3-H6, Roof Curb