WHAT’S INCLUDED:

• Vehicle Specific Wire Harness (P-BUA-TRANSIT)

COMPATIBLE ACCESSORIES:

• 97dB Backup Alarm (BUA-97C)

TOOLS REQUIRED:

1. 10mm Nut-setter
2. T-25 Torx Bit
3. Diagonal Cutters
4. Impact Drill

INSTALLATION INSTRUCTIONS

STEP 1:

Remove the (2) T-25 torque fasteners that are holding the tail lamp in place.

• Unplug the OEM tail lamp connection.
• Install the P-BUA-TRANSIT harness inline between the two OEM tail lamp connectors.
  

STEP 3:

Route the harness down through the bottom of the tail lamp opening, behind the bumper skin, and below the vehicle.

STEP 4:

Use an impact drill and 10mm nut-setter to install a compatible backup alarm beneath the driver side rear corner of the vehicle.

Note: (2) 10mm TEK screws are provided with the compatible backup alarm.

STEP 5:

Use the provided p-clamps and self tapping screws to secure the harness to the underside of the vehicle.

STEP 6:

Plug the backup alarm connector into the mating connector on the P-BUA-TRANSIT harness.

STEP 7:

Re-install the tail lamp assembly and test the backup alarm.

CUSTOMER SUPPORT

Phone – 866-931-2021(option 3)

E-Mail – support@aampglobal.com

AAMP Commercial is a Power Brand of AAMP Global

aampcommercial.com