BenQ V7000i Ultra Short Throw Projectors Installation Guide
What in The Box
Online Manual V7000i / V7050i / QS01
Before getting started
Check the size of your projection wall/screen and determine where to install the projector.
Note: For details for projector placement, see “Measurements” .
Remove packing materials.
Install batteries to dongle’s remote control
Connect ATV dongle and power cord
Place the projector
Measurements of 100″ projection screen
Measurements of 120″ projection screen
- Image size & aspect ratio Image dimensions
- Projector-screen surface distance
- TV shelf depth (Immobile)
- Image bottom- shelf surface distance
- TV shelf height (While image center at 1.4m high)
Note Values are provided for your quick installation. Fine adjustments may be required according to your needs.
Using the integrated measuring tool: to measure distance from projector to the wall
Power on and complete inital setup
Press OK on remote control to skip.
Note See “6. Screen adjustment” on page 9 for details.
How to adjust the screen
- Focus adjustment
> INSTALLATION > Motor Focus > Adjust
- Disable auto keystone
> INSTALLATION > Auto Keystone > Off
> INSTALLATION > Keystone > 0.0
- Screen edge adjustment
> INSTALLATION > Test Pattern > On
- Complete screen adjustment
Mark the position
The projector placement is complete. Mark the position if possible so you can align the projector again quickly once it is moved.
Documents / Resources
|BenQ V7000i Ultra Short Throw Projectors [pdf] Installation Guide|
V7000i, V7050i, Ultra Short Throw Projectors