ANANDA Check Brake Sensor Instructions

ANANDA-logo

ANANDA Check Brake Sensor

ANANDA-Check-Brake-Sensor-product

The content of this information is subject to change without notice

Installation Instruction

  1. Check whether the brake lever and mid-motor connector are plugged in properly, and replace the damaged part.
  2. Check whether the brake lever wire is damaged or crushed, and replace the damaged wire of the brake lever.
  3. Replace the brake lever.
  4. If the above items are in good condition, replace the midmotor.

Ananda Drive Techniques Co., Ltd.

Documents / Resources

PDF thumbnailCheck Brake Sensor
Instructions · Check Brake Sensor, Brake Sensor, Sensor

References

Ask a Question

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

Ask a Question

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.