UZ-2T Zigbee Temperature Humidity Sensor User Manual

UZ-2T Zigbee Temperature Humidity Sensor User Manual
UZ-2T Zigbee Temperature Humidity Sensor User Manual

  • Model:UZ-103T
  • Model:UZ-1T
  • Model:UZ-2T

Product presentation:

Product presentation

How to use:

Slide downwards to open the back cover of the battery compartment, install 2 x AAA new Alkaline batteries in the right direction of electrode, the indicator will biink, then push o close the back cover.
atteries are run out
(Notes: when batteries are run out, please choose *Model:uZ-1T ‘Alkaline battery instead of Carbon-zin battery.)

Specification:

Battery:LR03-1.5V/AAA*2(Alkaline battery)
Operating temperature: -10°C~55″C
Operating humidity: 0%~ 95% RH
Communication: Universal Zigbee3.0
Product size: 71x25x20mm
Temperature Measure Range: -9.9°C~60°C
Temperature Accuracy: £1°C
Humidity Measure Range: 0%RH~99%RH
Humidity Accuracy: £5%RH

Package contents:

  1. Host machine X1
  2. User Manual X1
  3. Foam X1
  4. Pins X1

Binding device description:

  1. Open the battery compartment on the back cover and install 2 x AAA new alkaline batteries in the correct electrode orientation.
  2. Make sure the LED indicator is flashing while connecting, if not, press and hold the reset button until the LED indicator is flashing fast or slow.
  3. Zigbee 3.0 protocol, please use your Gateway manual to configure

How to use:

Use a clean and dry towel to clean the area where you want to mount the sensor. Peel off the adhesive tape to stick on the back of sensor, press it hard to fix it well.
(The adhesive tape is for one-time use only.)
clean and dry towel
NOTES:
The sensor is only used in indoor and not water-proof.

Functions

  1. Accurate Measurement
    About 30 minutes after configuration done, the temperature and humidity is closer to the actual ambient environment, so the readings are more accurate.

FAQ

  1. Please use new alkaline battery, don’t mix use with used battery.
  2. Please configure network connection instantly after the batteries are installed, to avoid power consumption.
  3. When the ambient temperature change > 0.5 deg * C . or the humidity > 5% the temp and humidity will be updated every 2 minutes.
  4. When the ambient temperature change < 0.5 deg * C or the humidity change <5%, the temperature and humidity will be updated once an hour.

Documents / Resources

PDF thumbnailUZ-2T Zigbee Temperature Humidity Sensor
User Manual · Sensor, UZ-103T, UZ-1T, UZ-2T, Smart Home

References

Ask a Question

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

Ask a Question

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.