Zigbee GIRIER Switch Module (1CH-4CH)

TECHNICAL SPECIFICATIONS
| Product type | Zigbee Switch Module |
| Voltage | AC100-240V 50/60Hz |
| Max. load | 1CH: 10A/16A 2CH: 2x5A 3CH: 3×3.3A 4CH: 4×2.5A |
| Operation frequency | 2.405GHz-2.480GHz |
| Operation temp. | -10℃ to +40℃ |
| Protocol | IEEE802.15.4 |
| Operation range | <100m |
| Dims (WxDxH) | 39.2×39.2×18 mm |
| IP rating | IP20 |
| Warranty | 2 years |
| Certificates | CE, ROHS |

Overview

INSTALLATION
Warnings:
- Installation must be carried out by a qualified electrician in accordance with local regulations.
- Keep the device out of reach of children.
- Keep the device away from water , damp or hot environment.
- Install the device away from strong signal sources such as microwave oven that may cause signal interruption resulted to abnormal operation of the device.
- Obstruction by concrete wall or metallic materials may reduce the effective operation range of the device and should be avoided.
- Do NOT attempt to disassemble, repair or modify the device.
Wiring Instructions and Diagrams
- Turn off the power supply before carrying out any electrical installation work.
- Connect wires according to the wiring diagram.
- Insert the module into the junction box.
- Turn on the power supply and follow switch module configuration instructions.

1CH Zigbee Switch Module 
2CH Zigbee Switch Module 
3CH Zigbee Switch Module

4CH Zigbee Switch Module

- Scan the QR code to download Tuya Smart App, or you can also search keyword “Tuya Smart” at App Store or Googleplay to download App.
Log in or register your account with your mobile number or e-mail address.Type in the verification code sent to your mobile or mail box, then set your login password. Click “Create Family” to enter into the APP.
APP USER MANUAL
Open the control panel of the ZigBee gateway on the App
Before making the reset operation, pls make sure the Zigbee Gateway is added and installed to the WIFI network. Ensure that the product is within the range of Zigbee Gateway Network.
After the wiring of switch module is done, press the reset key for about 10 seconds or turn on/off the traditional switch for 5 times until the indicator light inside the module is flashing quickly for pairing.
- Click “+” (Add sub-device) to select the suitable product gateway and follow the on-screen instruction for paring.

- The connecting will take about 10-120 seconds to complete depending on your network condition. Finally, you can control the device via your mobile phone.

SYSTEM REQUIREMENTS
- WIFI Router
- ZigBee gateway
- iPhone, iPad (iOS 7.0 or higher)
- Android 4.0 or higher

Documents / Resources
![]() | Zigbee Switch Module (1CH-4CH) |
References
- User Manualmanual.tools
Published: November 18, 2026
