Linxup LinxCam Dash Camera Instructions

Linxup LinxCam Dash Camera

Specifications

Quick Setup & Use

1. Gather a Philips screwdriver, zip ties, a small spirit level, and electrical tape.
2. Install the mounting bracket near the windshield centerline, slightly below the rearview mirror. Level it, mark placement, clean the glass, and install the bracket with the toothed side facing right.
3. Attach the camera with buttons facing the driver and tighten the screw. Adjust the vertical angle for optimal visibility. Remove the blue protection film from both lenses (road-facing and driver-facing).
4. Route the cable above the windshield and down the door jamb using the provided tuck stick. Secure the OBDII camera power connector’s box near the OBDII port using its 3M adhesive pad. Attach the OBDII camera power connector to the OBDII splitter cable.
5. Activate: Log into the portal and go to “setup”. Add/activate the tracker (tracker setup > add new tracker) using the tracker’s activation code, then add/activate the camera (camera setup > add new camera) using the camera activation code.
6. Pair: In the tracker setup page, edit the tracker, choose the camera from the “camera” drop-down, and select the camera you want to pair.
7. Verify: Start the vehicle; the camera’s GREEN LED should illuminate. Live view may take up to 24 hours after activation. Confirm proper installation/placement in the portal or mobile app.

Step 6: Pair the Camera with your Tracker

From the tracker setup page:

• Click the edit button (pencil icon) next to the tracker to which you want to pair the camera.
• Click the drop-down under “camera” and choose the camera you want to pair with the tracker.

Step 7: Verify Operation

• Start the vehicle and the GREEN led light on the camera should illuminate.
• It can take up to 24 hours for the camera to activate before you can do a live view.
• Confirm proper installation and placement in live view from your portal or mobile app.

Need Additional Help?

How to install LinxCam scan code to watch a video

Activating + pairing scan code to watch a video

Maintenance and Cleaning

• Exterior Cleaning: Clean the camera housing with a soft, dry microfiber cloth.
• Exterior Lens Cleaning: Gently wipe the road-facing lens to remove dust, fingerprints, and smudges.
• Interior Lens Cleaning: Clean the driver-facing lens carefully to maintain clear cabin footage.
• Windshield Cleaning: Keep the windshield area in front of the camera free from dirt, condensation, and obstructions.
• Mounting Bracket Inspection: Check that the adhesive bracket remains firmly attached to the windshield.
• Camera Alignment: Periodically verify that both cameras remain correctly positioned.
• Cable Inspection: Have damaged or loose power cables inspected by a qualified technician.
• Power Connection Inspection: Ensure the approved power connections remain secure.
• Software Maintenance: Allow supported camera updates to complete according to the Linxup system instructions.
• Network Monitoring: Check the camera’s online status and cellular connectivity through the fleet management portal.

Safety Tips
Read the manufacturer’s installation instructions before use.

Troubleshooting

• Camera not ready for live view right away: It can take up to 24 hours for the camera to activate before live view is available.
• No GREEN LED when the vehicle is running: Verify installation and placement via the portal/mobile app and confirm the camera is properly installed and connected as described in the setup steps.