Lighting Light Fixture Assembly Instructions

Lighting-logo

Lighting Light Fixture

Lighting-Light-Fixture-PRODUCT

Quick Setup & Use

  • Before installation, turn electricity off at the main circuit breaker panel.
  • Assemble using the specified sequence: (1) C, B → A; (2) H, F → G; (3) E, I → D; (4) J → I; (5) M, L, K → J.
  • During disassembly, prevent the lampshade (K) from falling when removing the ball nuts (M).
  • After installation is complete, use the remote control to turn the light on/off and adjust brightness and color temperature.

CAUTION: Read instructions carefully and turn electricity off at main circuit breaker panel before beginning installation.

  • Warning: If any special control devices are used with this fixture, follow the instructions carefully to assure full compliance with N.E.C. requirements. If there are any questions, contact a qualified electric contractor.
  • Warning: California Residents Proposition 65 This product contains lead, a chemical known to the state of California to cause cancer and birth defects or other reproductive harm. Do not place the product in your mouth. Wash your hands after handling this product.
  • Caution: Electrician installation highly recommended. All glass is fragile, use care when handling glass component(s) and or lamp(s).
  • Read instructions carefully and turn electricity off at the main circuit breaker panel before beginning installation.

Important Notice: This is a generic instruction sheet used for various fixtures. Fixture shape and style may vary. Glass, Shade, Diffuser shape and style may vary.

Part Included

Lighting-Light-Fixture-fig-4

Assembly Instructions

ASSEMBLY STEPS

Lighting-Light-Fixture-fig-1 Lighting-Light-Fixture-fig-2

  • Prevent K from falling when disassembling M

Lighting-Light-Fixture-fig-3

  • After the installation is complete, the light can be turned on or off by remote control, and the luminaire brightness and color temperature can be adjusted.

Troubleshooting

  • Remote control not functioning: After installation, the light can be turned on/off by remote control and its brightness and color temperature can be adjusted. If operation is not as expected, review the assembly and ensure installation is complete before using the remote control.
  • Compliance concerns with special controls: If any special control devices are used with the fixture, follow their instructions to assure full compliance with NEC requirements or contact a qualified electrical contractor.

Documents / Resources

PDF thumbnailLight Fixture
Assembly Instructions · Lighting, Fixture

References

Ask a Question

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

Ask a Question

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.