aosu Wireless Security Camera

What’s Included
- Camera
- aosu Base
- Position Sticker
- Base Bracket
- Ethernet Cable
- Power Adapter for aosu Base
- USB-C Charging Cable
- Screw Pack
- Quick Start Guide
- Security Sticker

Product Overview
- Micro SD card slot
- Ethernet port
- SYNC button
- Power port
- Status LED
- Speaker

- Lens
- Infrared LEDs
- PIR Motion Sensor
- Microphone
- Base Bracket
- White LED spotlights
- Power
- Type-C Port
- Micro SD Card Slot
- Reset button

Connect the aosu Base
Power on the aosu Base. Connect it to your router using the included ethernet cable. Hold SYNC until blue light is blinking to connect to the network. 
System Setup: Power On the Camera
Press the power button to turn on the camera.

System Setup: App Connect
System Setup
Download the Aosu App from the App Store (iOS) or Google Ploy (Android), sign up for an account, then follow on-screen instructions to complete setup.

Mounting the Camera
Mounting the Camera-Height and Location
- Camera Field of View
- Motion Detection Zone
- 7-10 ft
- Up to 30 ft

Mount the Camera
The camera can be mounted both indoors and outdoors.
- Drill holes with a 15/64 inch (5.95mm) drill bit, then insert the anchors into the holes; anchors are necessary for walls that are made out of hard materials such as concrete, brick, or stucco. Firmly nailed the mounting base onto the wall.
- Accurately snap the camera to the mounting base.
- Adjust the viewing angle by checking the live stream feed in the “Aosu· App.

Charging the Camera
Method I & Method 2

FCC Statement
Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
FCC Radio Frequency Exposure Statement
The device has been evaluated to meet general RF exposure requirements. The device can be used in fixed/mobile exposure condition. The min separation distance is 20cm.
IC Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
IC RF Statement
This equipment complies with IC RSS -102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.
This product complies with the radio interference requirements of the European Community.”
Declaration of conformity
Hereby, Aosu declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. For the declaration of conformity, visit the Web site: https://www.aosulife.com. This product can be used across EU member states. Do not use the Device in the environment at too high or too low temperature, never expose the Device under strong sunshine or too wet environment. The suitable temperature for Camera and accessories is -10°C-50°C.
RF exposure information: The Maximum Permissible Exposure (MPE) level has been calculated based on a distance of d=20 cm between the device and the human body. To maintain compliance with RF exposure requirement, use product that maintain a 20cm distance between the device and human body.
For Camera : Wi-Fi Operating Frequency Range: 2412~2472MHz ; Wi-Fi Max Output Power: 17.13dBm(EIRP)
This product is designed and manufactured with high quality materials and components, which can be recycled and reused.
This symbol means the product must not be discarded as household waste, and should be delivered to an appropriate collection facility for recycling. Proper disposal and recycling helps protect natural resources, human health and the environment.” “For more information on disposal and recycling of this product, contact your local municipality. disposal service, or the shop where you bought this product.”
Limited warranty
I2-month limited warranty (The actual warranty period shall be implemented according to the requirements of local laws and regulations)
US +1-866-905-9950 Mon-Fri 9AM-5PM (PST)
support@aosulife.com
![]()
Documents / Resources
![]() | Wireless Security Camera |
References
- User Manualmanual.tools

