FENIX MC11 Angle Light User Guide

FENIX-logo

FENIX MC11 Angle Light

FENIX-MC11-Angle-Light-product

Technical Specifications

LED Cree XP-E LED (R2), lifespan 50,000 hours
Battery One 1.5V AA (Ni-MH or Alkaline)
Brightness (High / Mid / Low) 135 lm / 36 lm / 81 lm (listed output values)
Flashing Modes Strobe, SOS
Runtime High: 1h 43min; Mid: 6h 14min; Low: 53h (flashing modes: —)
Distance 87 m
Intensity 1910 cd
Impact Resistance 1.5 m
Waterproof IPX-8 (underwater 2 m)
Dimensions 99 mm (Length) × 21.5 mm (Diameter) × 25 mm (Head)
Weight 53.5 g (excluding batteries)
Accessories Clip, diffuser lens, lanyard

Quick Setup & Use

  • Insert a 1.5V AA battery, with the positive anode (+) pointing toward the light head, then screw the tail cap back on.
  • Press the top pushbutton to turn the light on/off.
  • General Mode brightness: In General Mode, press and hold the switch for over 0.7 seconds to cycle High → Low → Mid.
  • Flashing Mode: In Flashing Mode, press and hold the switch for over 0.7 seconds to cycle Strobe → SOS.
  • Switch modes: Rapidly double-press the switch to switch between General Mode and Flashing Mode.
  • Travel lockout: Unscrew the tail cap by half a turn to cut off power completely.
  • Multifunction use: Adjust the head angle and use the included clip for hands-free lighting; stand the light on its flat base for camping/task lighting. Use the included diffuser lens to soften the beam for close-up tasks.

Introduction

  • Fenix MC11 is a multifunctional angle light originally produced by Fenix.
  • It is very convenient to adjust the illuminating angle and the brightness. MC11 can be used as an L-shaped flashlight, camping light and headlamp, which can meet your various lighting needs. Offering 3 brightness levels and 2 flashing modes, waterproofing to IPX-8 Standard, MC11 must be your best choice for the multi-angle outdoor illumination with its convenience, exquisiteness and efficiency.

Technical Parameters

FENIX-MC11-Angle-Light-fig-1

  • Uses Cree XP-E LED (R2) with a lifespan of 50,000 hours
  • Uses one 1.5V AA (Ni-MH, Alkaline) battery
  • 99mm (Length) x 21.5mm (Diameter) x 25 mm (Head)
  • 53.5-gram weight (excluding batteries)
  • Digitally regulated output – maintains constant brightness
  • Reverse polarity protection, to protect from improper battery installation
  • Pushbutton switch
  • Made of high-class plastic and aluminum alloy
  • Aluminum alloy has the premium type III hard-anodized anti-abrasive finish
  • Toughened ultra-clear glass lens with anti-reflective coating

Notice: The above-mentioned parameters (tested by a 2500mAh Ni-MH battery in the lab) are approximate and may vary between flashlights, batteries, and environments.

Operation Instruction

Flashlight turning on/off

  • Depress the pushbutton switch on the top to turn on/off the light;

General mode

  • In the general mode, depress and hold the switch (for over 0.7 second), the light will change the brightness levels and will memorize automatically within 1 second working time.
  • The brightness levels are in the order of High→Low→Mid→Cycle;

Flashing mode

  • In the flashing mode, depress and hold the switch (for over 0.7 second), the light will change between different flashing functions and memorize automatically. Various flashing functions are in the order of Strobe→SOS→Cycle;

Mode selection

  • The default mode is the general mode. Depressing the switch twice rapidly can select between the general mode and the flashing mode.

Protective mode

  • Unscrew the tail cap for half a turn to cut off the power completely so as to avoid the light turning on carelessly.

Multifunctional Usage

  • L-shaped flashlight: MC11 can be fixed with a clip to some place such as waist belt, etc. To adjust the angle of the head can choose the suitable lighting direction.

Camping light

  • MC11 can stand on any flat surface and the downward illumination can be realized by adjusting the angle of the head.
  • It is convenient for reading, living and working. Using the diffuser lens together, it will turn into the flood light and provide better close illumination.

Battery Specifications

FENIX-MC11-Angle-Light-fig-2 FENIX-MC11-Angle-Light-fig-3

Battery Replacement

  • Unscrew the tail cap to insert the batteries with the anode side (+) toward the light head, and screw the tail cap to test.

Usage and Maintenance

  • Please don’t disassemble the sealed head; doing so can cause damage to the flashlight and will void the warranty.
  • High-power flashlights should use batteries with high current discharge ability; we suggest using high-performance Ni-MH rechargeable batteries. Using an alkaline battery will lower the runtime of a high-intensity flashlight.
  • Please use battery of high quality, and take out the battery if the flashlight will not be used for a long time, or it may cause damage from electrolyte leakage or battery explosion.
  • The o-ring may be worn out after using for a long time. If this happens, please replace the o-ring with a new one to keep the flashlight properly sealed against water.
  • Please clean the contacts of your light from time to time, especially if the light flickers or doesn’t light up. There may be several reasons for a flickering or not working light:
  • Reason A: The battery needs replacing.
  • Solution: Replace batteries (Please confirm the correct installation of anode and cathode).
  • Reason B: The threads, PCB board contact or other contacts are dirty.
  • Solution: Clean the contact points with an alcohol soaked cotton swab.
  • If the above methods don’t work, please contact the distributors and refer to the warranty policy.

Notice: The routine cleaning video can be watched and downloaded through the Fenix official website. Please log on to the service channel->’ maintenance for light’.

Product Warranty

  • We will replace products afflicted with manufacturing defects within 15 days of purchase and repair a light free of charge within 24 months of purchase if problems develop with normal use; if repair is required after 24 months from the date of purchase, we will charge for parts.
  • The total repair fee is dictated by the cost of the replaced materials.

Warranty Card Registration

  • We kindly suggest that you register your guarantee card on the official website for Fenixlight Limited. You can get an extra six-month warranty period once you have successfully registered.
  • What’s more, you could take part in the questionnaire lottery at the same time.

Warning

  • MC11 is a high-intensity lighting device and is capable of causing eye damage; avoid shining the light directly into the eyes.

Troubleshooting

Problem: Flickering or the light doesn’t turn on

  • Reason A: Battery is depleted.
    Solution: Replace the battery and confirm correct polarity (+ and -) orientation.
  • Reason B: Dirty threads/PCB/contact points.
    Solution: Clean the contact points using a cotton swab dipped in rubbing alcohol.
  • If not resolved: Contact your local distributor and refer to the warranty policy.

CONTACT

  • FENIXLIGHT LIMITED
  • Tel: +86-755-29631163/83/93 Fax: +86-755-29631181
  • http:www.fenixlight.com
  • E-mail:info@fenixlight.com
  • Address: 8/F, 2nd Building, DongFangMing
  • Industrial Center, 33rd District, Bao’an,
  • Shenzhen 518133, China

Documents / Resources

PDF thumbnailMC11 Angle Light
User Guide · MC11 Angle Light, MC11, Angle Light, Light

References

Ask a Question

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

Ask a Question

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.