Fenix TK15UE Flashlight
Instruction Manual
The Fenix TK15UE defines extreme ruggedness. This light employs the new CREE XP-L HI V3 LED technology, which allows the light to throw an impressive beam distance of 325 meters and deliver a maximum output of 1000 lumens. With an impact-resistant strike-face bezel, the TK15UE is ready for heavy-duty action. Complete with a tactical tail switch with momentary capability and a side switch to access four brightness levels and Strobe, this tactical light is built to assist law enforcement, search and rescue, military, and more.
Technical Parameters
| ANSI/PLATO FL1 | Turbo | High | Mid | Low | Strobe |
| 1000 Lumens |
350 Lumens |
150 Lumens |
10 Lumens |
1000 Lumens |
|
| 2h* | 4h 20min | 11h 30min | 135h | / | |
| 325m | 194m | 125m | 31m | / | |
Intensity |
26400cd | 9400cd | 3900cd | 240cd | / |
Impact Resistance |
1m | ||||
| IPX-8, underwater 2m | |||||
| Accessories | Holster, lanyard, spare O-ring, spare rubber switch boot | ||||
Notice: The above-mentioned parameters (lab-tested by using Fenix 18650 rechargeable Li-ion battery 3.6V/3500mAh) are approximate and may vary between flashlights, batteries, and environments.
*Due to intelligent over-heat protection, the runtime of the Turbo brightness level is the accumulated time.
Uses Cree XP-L HI V3 LED with a lifespan of 50,000 hours
Powered by one 18650 rechargeable Li-ion battery or two CR123A Lithium batteries
142.5mm Length x 25.4mm Body Diameter x 34mm Head Diameter
141 grams (excluding battery)
Compatible with AER-01/AER-02 remote pressure switch
Digitally regulated output maintains constant brightness
Reverse polarity protection to protect from improper battery installation
Anti-roll and anti-slip body design
Tactical tail switch for momentary-on function
Functional side switch for output selection
Made of durable aircraft-grade aluminum
Premium type hard-anodized anti-abrasive finishⅢ
Toughened ultra-clear glass lens with anti-reflective coating
Operation Instruction
The tail switch is a tactical switch; the side switch is a functional switch.
ON/OFF
Tap the tactical tail switch to momentarily turn on the light; release it, and the light will go out.
Fully press the tactical switch to turn on the light constantly; press again to turn off the light.
Output Selection
With the light on, single-click the functional switch to cycle through
Turbo→Low→Mid→High.
Strobe
With the light on, press and hold the functional switch for 0.5 seconds to enter Strobe mode; click once again to return back to General mode.
Intelligent Memory Circuit
The flashlight memorizes the last brightness used in the General mode; the next time it is turned on, it will recall that previously used brightness level.
Overheat Protection
The flashlight will accumulate a lot of heat when it is working at Turbo. When the light is overheated to 65 or above, the flashlight will automatically adjust the output in℃ stepped way to prevent the light from overheating.
Low-voltage Warning Function
If low voltage is detected, the flashlight is programmed to downshift to a lower brightness level until to Low brightness level. When this happens at Low output mode, the flashlight blinks three times every five minutes to remind you to replace the battery. To ensure normal use, the flashlight will not turn off automatically and will work until the battery runs out completely.
Battery Specifications
| Type | Dimensions | Nominal Voltage | Usability | |
| Fenix ARB-L18 Series | 18650 | 3.6V/3.7V | Recommended | √√ |
| Fenix ARB-L2 Series | 18650 | 3.6V/3.7V | Recommended | √√ |
| Non-rechargeable Battery (Lithium) | CR123A | 3V | Usable | √ |
| Rechargeable Battery (Li-ion) | 18650 | 3.6V/3.7V | Cautious* | ! |
| Rechargeable Battery (Li-ion) | 16340 | 3.6V/3.7V | Cautious* | ! |
| Rechargeable Battery (LiFePO4) | 18650 | 3.2V | Banned | × |
Warning: Please do not mix batteries of different brands, sizes, capacities, or types. Doing so can cause damage to the flashlight or the batteries being used.
*18650/16340 Li-ion batteries are powerful cells designed for commercial applications and must be treated with caution and handled with care. Quality batteries with circuit protection will reduce the potential for combustion or explosion, but cell damage or short circuiting are potential risks the user assumes.
Battery Replacement
Unscrew the tail cap to insert the battery with the anode side (+) towards the light head, and then screw the tail cap.
Usage and Maintenance
Disassembling the sealed head can cause damage to the light and will void the warranty.
Fenix recommends using an excellent quality battery. If the light will not be used for an extended period, remove the battery, or the light could be damaged by electrolyte leakage or battery explosion.
Unscrew the tail cap one-half turn or take out the battery to prevent accidental activation during storage or transportation.
Long-term use can result in O-ring wear. To maintain a proper water seal, replace the ring with an approved spare.
Periodic cleaning of the battery contacts improves the lamp’s performance, as dirty contacts may cause the lamp to flicker, shine intermittently, or even fail to illuminate for the following reasons:
Reason A: The batteries need replacing.
Solution: Replace batteries (Please confirm the correct installation of anode and cathode).
Reason B: The threads, PCB board contact, or other contacts are dirty.
Solution: Clean the contact points with a cotton swab soaked in rubbing alcohol.
If the above methods don’t work, please refer to the warranty policy before contacting your authorized distributor.
Product Warranty
Fenix will replace products with documented manufacturing defects within 15 days of purchase and repair a light free of charge within 5 years of purchase if problems develop with normal use; if repair is required after 5 years from the date of purchase, Fenix will charge for parts. The total repair fee is dictated by the cost of the replaced materials.
Product Registration
Fenix suggests you register your product on the official website for Fenixlight Limited (www.fenixlight.com). You can get an extra six-month warranty period once you have successfully registered.
Warning
The flashlight is a high-intensity lighting device capable of causing eye damage to the user or others. Avoid shining the flashlight directly into anyone’s eyes.
Available Accessories
| Type | Model |
| Diffuser tip | AOD-M |
| Traffic wand | AOT-M |
| Filter adapter | AOF-M |
| Remote switch | AER-01/02 |
| Bike mount | ALB-10 |
| Rail mount | ALG-01 |
Note: For full details about available accessories, please visit the Fenix Tactical website, click on Products, followed by clicking through to the Accessories page.

Documents / Resources
![]() | TK15UE Flashlight |
References
- fenixlight.comwww.fenixlight.com
- User Manualmanual.tools
Intensity
Impact Resistance