LiftMaster 893MAX Three Button Remote Control Instruction Manual

LiftMaster-LOGO

LiftMaster 893MAX Three Button Remote Control

LiftMaster-893MAX-Three-Button-Remote-Control-PRODUCT

893MAX REMOTE MANUAL FOR OPERATOR WITH LEARN BUTTON
Remote to control up to 3 residential or commercial operators of the Liftmaster, Chamberlain, Craftsman, Raynor, Merik brands manufactured after January 1, 1993 with Technology, Security +2.0, Security + 315Mhz, Security + 390Mhz, Billion Code.

PREPARE

  • Locate the Learn button on the garage door opener.
  • NOTE: Your garage door opener may look different.
  • Locate the Program button on the remote control.

LiftMaster-893MAX-Three-Button-Remote-Control (9)

PROGRAMMING THE REMOTE CONTROL

  1. Press and hold the program button the remote control until the LED on the front of the remote control turns on.
  2. LiftMaster-893MAX-Three-Button-Remote-Control (8)Press and release the Learn button on the garage door opener. LiftMaster-893MAX-Three-Button-Remote-Control (7)
  3. Press and release the desired button on your remote control. Observe the light bulb fitted on the garage door opener to check for blinking. Stop all button operations immediately once the bulb blinks. Repeat the above operation until the garage door opener bulb blinks
  4. LiftMaster-893MAX-Three-Button-Remote-Control (6)To exit programming mode, press any remote control button except the button that was just programmed.LiftMaster-893MAX-Three-Button-Remote-Control (5)
  5. To test, press the programmed button on the remote control. The garage door opener will activate.LiftMaster-893MAX-Three-Button-Remote-Control (4)
  6. Install the visor clip (not applicable for Model 890MAX).

LiftMaster-893MAX-Three-Button-Remote-Control (3)

Battery
The LED(s) on your remote control will stop flashing when the battery is low and needs to be replaced. To replace the battery, open the case as shown. Insert battery positive side up (+). Replace the battery with only 3V2032 or 3V2016 coin cell batteries (depending on the model). Dispose of old battery properly.

  • 893MAX: Pry open the case first in the middle, then at each side with the visor clip.
  • Pry open the case with a screwdriver blade.

LiftMaster-893MAX-Three-Button-Remote-Control (2)

WARNING To prevent possible SERIOUS INJURY or DEATH:

  • NEVER allow small children near batteries
  • If battery is swallowed, immediately notify doctor.

To reduce risk of fire, explosion or chemical burn:

  • Replace ONLY with 3V2032 coin batteries.
  • DO NOT recharge, disassemble, heat above 212° F (100° C) or incinerate.

FCC STATEMENT

NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. This device complies with Part 15 of the FCC rules and IC RSS- 210. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. This device must accept any interference received, including interference that may cause undesired operation.

Documents / Resources

PDF thumbnail893MAX Three Button Remote Control
Instruction Manual · 893MAX Three Button Remote Control, 893MAX, Three Button Remote Control, Remote Control

References

Ask a Question

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

Ask a Question

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.