FuelTech Fuel Injector

Specifications
- Product Name: Fuel Injector
- Product Category: Auto Engine Parts – Fuel Supply System Components – Fuel Injector
- Product Material: High-strength corrosion-resistant metal, precision engineering plastic, high-density sealing rubber parts
Safety Warning Notice
- Unauthorized Disassembly Prohibited: Do not disassemble or reinstall without professional knowledge and proper tools.
- ⚠ Prevent Misuse: For use with designated models only.
Product Basic Information
- Product Name: Fuel Injector
- Product Category: Auto Engine Parts- Fuel Supply System Components- Fuel Injector
- Product Material: High-strength corrosion-resistant metal, precision engineering plastic, high-density sealing rubber parts
Instructions for Use
- Park the vehicle in a ventilated, fire-free safe area, turn off the engine completely, disconnect the negative battery terminal to cut off power, and fully relieve the fuel system pressure before operation.
- Clean the surrounding area of the original fuel injector, remove dust, oil stains and impurities, disassemble the fuel pipe, wiring harness and fixing buckles of the injector in sequence, and keep the removed parts properly.
- Take out the new fuel injector, check the appearance for damage, blockage or sealing defect. Always install new O-rings / seals, and apply a small amount of clean engine oil or silicone lubricant to the seal surfaces.
- Install the new injector, aligning with the original mounting hole position, ensure it is firmly seated without skew, reconnect the fuel pipe and wiring harness, and fasten all fixing parts tightly.
- Restore the vehicle power supply, turn on the ignition switch (do not start the engine) to pressurize the fuel system, check for fuel leakage at the injector and pipeline joints.
- Start the engine after confirming no leakage, idle and run it stably for 5-10 minutes, check for abnormal noise, unstable idle speed or fuel leakage, and debug the engine normally.
Usage Restrictions
Only use qualified fuel that meets national or regional standards. The use of impure, deteriorated or substandard fuel is strictly prohibited to prevent fuel injector blockage and wear. Do not modify the injector structure, fuel pressure or circuit parameters without authorization. Do not use it on incompatible models or with faulty injectors. This product is only intended for replacing the original damaged injectors of the corresponding models. It is not designed for any modification that violates engine operating specifications.
After-sales Notice
Please inspect the product promptly upon receipt to check for any damage or missing accessories. For non-human-induced quality issues, please contact after-sales support with your order information. Product failures caused by improper installation, use of unqualified fuel, man-made damage, unauthorized modification, natural wear and tear, or improper use are not covered under warranty. The warranty period is stated on the product details page. Normal returns, replacements and after-sales service will be provided for non-human-induced quality issues within the warranty period.
Frequently Asked Questions (FAQs)
Uneven Fuel Spray: Check fuel pressure or clean the injector nozzle.
Documents / Resources
![]() | Fuel Injector |
References
- User Manualmanual.tools
