Outwell Encounter Cloud 5 Installation Guide

Outwell-LOGO

Outwell Encounter Cloud 5

Outwell-Encounter-Cloud-5-PRODUCT

Specifications

Feature Detail
Tent type Two‑room dome‑style tent / extended‑dome with porch / living area + sleeping area
Capacity Sleeps up to 5 people
Flysheet / Outer Fabric Outtex® 3000 Select polyester (100% polyester)
Waterproof Rating (Flysheet) Hydrostatic head: 3000 mm — good rain protection
Floor / Groundsheet Double‑coated waterproof polyethylene (inner floor / bathtub floor)
Poles / Frame Duratec fibreglass, 11 mm diameter poles
Dimensions (L × W × H) ~ 360 cm × 320 cm × 185 cm (length × width × max height)
Packed Size About 63 × 22 cm (other sources say 65 × 22 cm)
Weight Approximately 8.7 – 9.0 kg depending on spec source
Setup / Pitch Time ~ 14 minutes for full setup; ~ 7 minutes to have it “ready to move in”
Ventilation & Features Rear ventilation opening, mesh pockets inside, dark inner to reduce light (better for sleep), sealed inner floor for insect protection, detachable/ bathtub groundsheet in porch area, tinted windows, reinforced stress points, heavy-duty zips.

ASSEMBLY

Outwell-Encounter-Cloud-5-FIG- (1) Outwell-Encounter-Cloud-5-FIG- (2) Outwell-Encounter-Cloud-5-FIG- (3)

Cleaning and maintenance tips

  • Congratulation on your new innovative Outwell@ Tent designed and created to accompany you out into the great outdoors.
  • Be aware that (UV) ultraviolet rays will damage your tent if you expose it to direct sunlight for longer periods of time. Outtex fabric used on Outwell@ tents increases the lifetime of the tent.
  • Outwell Product are made for camping use which is normally 2-5 weeks usage a year. They are not designed for permanent usage and should only be used as camping products.
  • Camping near the sea or lake can further enhance the effect of UV radiation. The same applies to poles and metal parts.
  • Select the campsite and position the tent
  • Open the bag and as you take out the tent look at the way it has been packed. This will help you when you come to repack it.
  • When selecting your campsite, the ideal place would be an area as even and clean of rocks, branches, and other sharp objects as possible.
  • Spread out the tent and place it with the door in the desired direction. Avoid placing the tent directly under trees, and position it with the end into the wind direction, for best results in windy conditions.
  • Get the most out of your camping trip by having a trial run, putting up and taking down your new tent in order to know it before you use it for the first time.
  • Under certain weather conditions, condensation can occur on the inside surfaces of your tent. To help prevent this you must remove wet clothes etc., increase ventilation or erect your tent on an Outwell Footprint.
  • Condensation should not be confused with leakage.
  • The flysheet is made of waterproof material. To prevent water from seeping through the flysheet avoid touching the inside surface in rainy weather conditions.
  • When erecting your tent, do not secure it too tightly, otherwise it will not be able to adapt to varying wind and weather conditions.
  • If strong winds are expected, replace the normal tent pegs with storm pegs, Do not use guylines to pull out the tent pegs. For stony or hard ground stronger U-form pegs are recommended.

Insecticides must not be sprayed in or on the tent as they may damage the fabric and coating!

  • When taking down and packing the tent, it must be completely dry to avoid mildew/rotting. We recommend that after use all metal poles be lightly greased with a nonacidic Oil.
  • Remove dirt from the tent with a soft sponge and pure water. Never wash the tent in a washing machine and never have it dry-cleaned. Store the tent in a dry place.
  • Even though we have used special waterproof thread for all seams, we recommend that you use a seam sealer or a waterproof spray at regular intervals for all seams around the zips and toggles, these seams are some of the weaker points on your tent as there can be a lot of tension around them.
  • Please note that the tape may come off after prolonged exposure to the sun. If this happens you can repair your tent by removing loose tape and use a seam sealer and waterproof spray to re-seal seams.
  • If a minor water leak is found from taping this can easily be re-sealed using a seam sealer — the leak can happen from single thread uncovered by tape a Simple fold in  the covering tape or similar by human made workflows.
  • We recommend using Outwell Waterguard on regular intervals on the flysheet material to increase the life span.
  • If your tent has a mud valance never use it to adjust the tent or use the mud valance to pull the tent pegs out. The mud valance is one of the weaker points on the tent as it is only designed to keep wind and water out Of the living and storage area.

Taking down your tent

  • When detachable take out the groundsheet and clean it if necessary with a sponge and water. Clean dirty floors the same way. (Allow it to dry before packing the tent).
  • If the inner tent is wet or dirty, take it out and clean it, the tent can be packed down with or without the inner tent inside.
  • Then start to unpeg the tent and the guylines. Gently remove the poles from the pins and then gently push the poles through the sleeves. Do not pull the poles through!
  • You are now ready to fold the tent. Try to fold it so you have all metal pins/rings at one side (to prevent them from making holes in the flysheet).
  • When you have folded the tent, measure it with the carrybag to make sure it is not too wide. You should now be able to roll the tent round the poles in their pole bag and fit it into the Outwell carrybag.

Best regards, THE OUTWELL TEAM

Outwell Wind Stabilizer System

  • Testing and determination of Outwell Wind Stabilizer
  • System (OWS System) performance and matching Beaufort ratings is based on the knowledge and technique available to Outwell at the time of testing. Outwell is not responsible if a subsequent development may show that Outwell’s knowledge and technique is flawed or incorrect. The ratings to this tent are obtained by erecting and testing similar tents at the facilities of Oase Outdoors ApS. The ratings are therefore no guarantee for the properties of this tent.
  • Factors such as varying ground conditions, inadequate pegs, sun, rain, temperature, other weather conditions, defective or incorrect erection of the tent and normal wear and tear can lead to a performance of the tent that differs from the specified ratings.

For more info on tips and maintenance please visit outwell.com

  • Please direct product claims and problems to your supplying Outwell dealer.

Safety

  • The tent is intended as a camp/touring tent, not for permanent long-term installation. Prolonged exposure (especially in strong UV or near saltwater) can degrade materials over time.
  • Always pitch on flat ground and avoid sharp or abrasive surfaces — this protects the groundsheet and floor from damage. If possible, use a tarp or footprint under the tent for added protection.
  • Ventilation is important — even though the tent is waterproof, condensation can develop. Use the rear ventilation openings to promote airflow
  • Don’t over-tension guy lines or poles — while the structure is stable (with a “Wind Guard” system), incorrect tension might strain seams or damage poles.
  • Dry thoroughly before packing — if fabric or floor remain damp, mold or mildew might develop during storage.

FAQs

Q1: Is the tent suitable for rainy or windy weather?

A: Yes — the tent’s flysheet has 3000 mm hydrostatic head rating, the seams are fully sealed, and the groundsheet is double‑coated waterproof polyethylene. The fibreglass pole frame with the brand’s “Wind Guard” reinforcement gives a decent stability in normal wind conditions, making it a good option for typical 3‑season camping.

Documents / Resources

PDF thumbnailEncounter Cloud 5
Installation Guide · Encounter Cloud 5, Encounter Cloud 5, Encounter, Cloud 5

References

Ask a Question

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

Ask a Question

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.