AkaGear ‎DS10 User Guide

‎DS10

1. Quick set

1. The default programming code is “123456”, It’s required that you change it
   to a code of your owm before programming.
2. Recommend you hit the small reset button on the circuit board before
   assembling the unit to the bracket.
3. Programming Code = PC User Code = UC
   Press +number to enter into the programming mode

2. Features

• Three ways to access: code, key and fingerprint.
• Low power consumption, 4 AA batterise can work for 1 year or 5000 times.
• Backlit keypad for use in low light environments.
• 1 Programming Code and 300 user codes (Including 50 Fingerprints).
• Built-in disguise feature to protect your codes from prying eyes.
• Low battery warning indication.

3. How to use ?

Unlock the from outside

Lock the door from outside

Auto lock mode

• Auto lock mode is disabled by default, please refer “Quick set” turn Auto-lock on steps.
• In auto lock mode, the bolt extend out automatically in 5/10/20/30/60 seconds after unlocking.

Manual mode

Lock the door from inside

Deadlock / Privacy Button

• Privacy mode is disabled by default.
• All Entery Codes are disabled except the programming code.

Manual mode

Rotate the turn piece to lock position.

Indicator light signals

Green: A correct code was entered.
Blue: Programming in progress.
Red:

• An incorrect code was entered.
• Programming error.
• Low battery warning.

4. Privacy mode

Reset mode

Step 1:
Remove the battery cover.

Step 2:
Put four AA batteries in and subsequently long-press
the “Deadbolt” button. The blue light will then flash.

Step 3:
Enter “000 + ” and the green light flashes
means the reset is successful.

Deadlock Button

After the Deadlock function is turned on, only the Programming Code can unlock, and
all user code cannot unlock (use the Programming Code to unlock the lock will
remove the Deadlock restriction.)

5. Restore factory settings

Delete all user codes, including master
code:

• Use a Screwdriver to remove the interior
  assembly.
• Press and hold the reset button for 5 seconds
  until voice prompt & green light flashing, the
  master code will return to the manufacturer
  default code “123456”.

After restore factory, Change the master passcode as soon as possible! Because of the
master password can unlock the door.

5. Setting definitions

Warranty
Lifelime limited Mechanical and Finish Waranty and 1-Year Limited Electronics Warranty Subiect to the terms and
conditions of the warranty.We extend a lifetime limited mechanical and finish warranty and a 1-year limited
electronics warranty to the original consumer user(“Original User” ) of our brand product against defects in material
and workmanship, as long as the original User occupies the residential premises upon which the product was
originally installed.

Warnning
This manufacturer advises that no lock can provide complete security by itself, this lock maybe defeated by forcible
or technical means or evaded by entry else where on the property.No lock can substitute for caution, awareness of
your environment, and common sense.Builder’s hardware is available in multiple performance grades to suit the
application.ln order to enhance security and reduce risk, you should consult a qualified technician or other security
professional.

6. Troubleshooting

Installation

Operation

7. Contact Us

(888) 811-1140(US) cs@akagear.net www.akagear.net
For any inquiries about AkaGear products, please feel free to contacts us.
Operating Hours: Mon-Fri 9am-5pm (EST)