VLAND Head Light

FUNCTION DESCRIPTION

Turn signal Light: NONE
Please note that the headlights do not have a turn signal function; the turn signal function is on the front bumper light.

NOTE
PLUG & PLAY. THE ITEMS HAVE THE SAME CONNECTIONS AND WIRES AS THE ORIGINAL HEADLIGHTS.
SUGGESTED INSTALLATION TOOLS

- (Please use safe precautions
- Vland highly recommends professional installation
Istallation Tips
- Always wear eye protection and safety gloves to avoid any possible injuries.
- DO NOT cut or connect any wires without identifying them to avoid any possible electrical short circuit.
- Vland recommends soldering each wire connection for optimal connectivity.
- Please check to ensure no electrical connection is exposed after installation.
- To prevent damage to the product or vehicle, please use electrical tape or zip ties to organize loose wires.
- Note: Installation may vary depending on the vehicle.
- Removal of your vehicle’s bumper may be required.
- Warning: Please use the recommended safety equipment when installing
- Vland Headlights. Vland is not liable for any injuries or accidents that may occur during installation.
WARNING: PRE-INSTALLATION CHECK LIST
- Please read carefully before installation
- Professional installation is highly recommended.
- Vland is not responsible for any damages or injuries due to improper installation.

Note
The above figure is a demonstration of individual errors, not only for this product. Make sure you install it properly to avoid installation gaps, water leakage, and other situations.
CONDENSATION
Condensation Vs. Water Leak
Manufacturers’ note: Condensation is a common problem that all car light manufacturers encounter. Climate change, the humidity in the headlights can cause fog. Once the headlights are turned on, the heat produced by the bulb will cause condensation.

- A. Slight fog or light condensation is normal. If this happens, park your vehicle in the sun to alleviate the condensation. Then, reseat all gaskets and caps to ensure they are tightly sealed.
- B. This is an image of an actual water leak. If this occurs, please refer to your warranty guide, either found in your packaging, or please visit our website for more information. To prevent condensation, please check that all rubber gaskets, seals, and o-rings are tightly sealed and secured.

Helpful hints
- Fitment is not guaranteed if the vehicle has been in a prior collision.
- To avoid scratches and damage to your Vland Headlight. Never lay the item on the lens face down, as shown in Fig C.
- Do not modify, alter, or tamper with this product in any way. Failure to comply will void your warranty.
- Warning: Do not attempt to re-seal, bake, or rinse your headlights out. This can cause damage to your headlights and their internal electronic components.
HEADLIGHT ADJUSTMENT
Four different types of adjusters are located behind your headlight. Identify which adjuster your product is equipped with and use the correct tool for adjustments. Locate the adjustment knobtand turn it to the appropriate height.
(Disclaimer: Vland will not be held responsible for any incidents that may occur as a direct result of improper headlight adjustments)

Note: Please do not use any power tools on adjustments. Vland is not liable for any damages caused by over-tightening or improperly adjusting your headlights.
If your vehicle suspension is lowered or lifted, please adjust accordingly. Black will always be a ground wire. Any colored wire, including white, is a power wire and will be hooked up to running lights.

Most headlights feature individual.
LEDs to add an extra accent to enhance the appearance of your vehicle.

- Warning: Vland does not recommend self-installation for any electrical wiring.
- We highly recommend trained professionals to connect your electrical components.
- Vland is not liable for any damages or injuries due to improper installation.
- Note: Image displays are for instructional purposes only. The product may vary.

After-sale service
ZHEJIANG HONGGUAN ILLUMINATION TECHNOLOGY CO., LTD
(Telephone hotline): 86-400-6677555
E-mail:business@vlandshop.com support@vlandshop.com
(Web): www.vlandshop.com
Add: NO.185, FENGDU 2ND ROAD, NORTHLUOFENG
INDUSTRIAL AREA, TANGXIA, RUIAN, ZHEJIANG, CHINA
Documents / Resources
![]() | Head Light |
References
- User Manualmanual.tools


Доброго дня чому ви продаєте такі хуйові рефлектори які за рік експлуатації вийшли зі строю, тому що пропустили вологу,і друге питання чі може замовити у вас запчастини до ремонту рефлектоа
Why did my reflectors fail due to moisture after one year, and can I order replacement parts for repair?
We are sorry to hear about the issues with your VLAND headlights. According to the manual and manufacturer's policy, here is the information regarding moisture and repairs:
VLAND Contact Information:
Email: support@vlandshop.com or business@vlandshop.com
After-Sales Form: Available on their official website at www.vlandshop.com.
To prevent future moisture issues, ensure all rubber gaskets, seals, and o-rings are tightly secured during installation.
Read the full Q&A page