filex ELO Electronic Lock

General

- Reset button
- Battery compartment
- Bolts
- Lock
- Yellow light (
) - Red light (
) - Greenlight (OK)
- Confirmation button
- Emergency lock cover
Installation
To reduce the risk of theft of your Filex product, we recommend to fix your Filex product to the floor and / or wall. Please use the supplied fixing bolts for this.
- Place the Filex product in position.
- Check if the door opens and closes smoothly.
- Mark the drill points through the pre-drilled holes.
- Remove the Filex product and drill 8 mm fixing holes.
- Remove any dust from the fixing holes.
- Place the Filex product back in position, insert fixing bolts and tighten to secure.

Opening your Filex product for the first time

Please use the emergency key to open the Filex product for the first time. Remove the emergency lock cover, insert the emergency key and turn it counterclockwise. Now turn the lock clockwise to open the door.
Attention: we recommend storing the emergency keys in a secure place after you have opened the Filex and have set up your user code. Please never store the emergency keys inside the Filex product!
Inserting batteries
The Filex electronic lock operates on four AA batteries. Please remove the cover of the battery compartment on the inside of the door and insert four batteries. If the red light flashes, it means the batteries are almost empty and should be replaced.
Attention: if changing batteries takes longer than thirty minutes, the user code is erased and should be programmed again. Please read chapter 5 ‘Setting the User Code’ for further instructions.
Setting the user code
Push the red reset button on the back of the door. When you press this button, the yellow light will flash. Now enter your new user code (three to eight digits) and press ‘A’ or ‘B’ to confirm your new user code. When you hear two beeps, the new user code has been accepted and stored. Please test your new user code several times with the door open.
If the yellow light flashes and you hear three beeps, the user code has not been accepted and should be set up again.
Opening the Filex product
Enter your user code. Each key entry is confirmed by a yellow light and a beep. Press ‘A’ or ‘B’ to confirm your code. The green light will flash. You now have five seconds to open the door by turning the lock
clockwise.
Manipulation protection
The key pad will be automatically blocked for twenty seconds after three consecutive invalid user code entries. Entry of three more invalid user codes will start a further five-minute blocking period.
Attention: during the blocking period you can stop the warning signal only by opening the Filex product with the emergency keys and removing the batteries.
Do you have any questions about your Filex product, the electronic lock or is there an unexpected malfunction? Please contact the dealer where you purchased your Filex product for support.
Do you have any questions about your Filex product, or would you like to know more about the other products? Ask for it at your local dealer.



Documents / Resources
![]() | ELO Electronic Lock |
![]() | ELO Electronic Lock |
References
- User Manualmanual.tools

