Installation Instructions
of Door knob
Installation Guide
KS02B Door Knobs
Thank you fo purchasing aur products. Please review this manual thoroughly baforo operatng your dovice.
Al pictures i this manual are fo istration purpos only. Actual procuct may vary us to product upgrace.
Parts list
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |

Prepare the door and check dimensions
If your door already has the holes shown in the picture below, proceed to the next step, if your door does not have holes, use the mounting template to drill a new hole. 
Latch backset adjustment
Backset is the distance from the door edge to the center of the hole in the door.
The latch is provided with adjustable design which can fit either 2-3/8″(60mm) or 2-3/4”(70mm) backset.
A. If the backset of your door is 2-3/8″(60mm), no need to adjust the latch.
B. If the backset of your door is 2-3/4″(70mm), please adjust the latch. 
Install latch and strike

Important: The latch should be aligned with the chiseled property.
Important: Make sure the hole in door frame is drilled a minimum of 1″ (25mm) deep.
Install front and rear knob

Test the knob
Keep the door open, checking out front and rear knob to test if it works properly. 

Documents / Resources
![]() | KS02B Door Knobs |
References
- User Manualmanual.tools






