DFI Windshield Defender Kit Instructions

DFI - logoWindshield Defender™ Kit

DFI Windshield Defender Kit -

Application Instructions

  1. Start by wetting the glass and using the white scrubber pad with the Restoration Powder™ to prep the glass for the Windshield Defender™ application. Make sure to remove all dirt, water spots, etc.
  2. Once thoroughly clean and dry, apply the Windshield Defender™ protective coating using firm circular, overlapping motions, going over the entire area at least twice.
  3. To test the application, spray the glass, and look for uniform water beads. For areas that are not beading up uniformly, dry the entire surface and reapply the Windshield Defender™ coating as needed.
  4. Finalize the application process by polishing the glass with the microfiber towel. If preferred, you may wash the windshield with soapy water.

Important:

Do not apply the Windshield Defender™ coating in direct sunlight and do not unfold the towelette immediately upon removal of the package; only unfold as needed.

DFI - logo© Diamon-Fusion Interational, Inc. Al rights reserved.

Documents / Resources

PDF thumbnailWindshield Defender Kit
Instructions · Windshield Defender Kit, Defender Kit, Kit

References

Ask a Question

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

Ask a Question

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.